SMT007 Magazine

SMT007-Oct2019

Issue link: http://iconnect007.uberflip.com/i/1172746

Contents of this Issue

Navigation

Page 59 of 101

60 SMT007 MAGAZINE I OCTOBER 2019 There are various soldering methods, such as hand soldering, wave soldering, reflow sol- dering (e.g., vapor phase, convection reflow), and selective soldering. Some of these pro- cesses have been around for many years, while others were introduced more recently. All of these processes have unique character- istics, advantages, disadvantages, and appli- cations. For example, no process can compete with the cost-effectiveness of wave soldering for through-hole board assemblies. Similarly, if the board contains only surface-mount com- ponents, the predominant soldering process choice is convection reflow. If you have to deal with mixed-assembly boards with both surface-mount and through- hole components—as is the case today for more than 95% of electronic products—the selection Today's Soldering Options of a soldering process becomes more complex, especially if you use both tin-lead and lead- free components on the same board. Soldering Options Vapor phase soldering (VPS), also known as condensation soldering, has gone through changes in popularity. Once the process of choice in the early 1980s, its use has declined considerably for two reasons: problems with the VPS process itself and improvements in the convection reflow process. The problems with VPS are mostly in the areas of higher defects, such as wicking mostly in J-leaded parts and tombstoning in chip components. However, the incidence of wicking in VPS has essentially gone away since J-leaded com- ponents are rare today. J-lead devices have SMT Solver by Ray Prasad, RAY PRASAD CONSULTANCY GROUP

Articles in this issue

Archives of this issue

view archives of SMT007 Magazine - SMT007-Oct2019