PCB007 Magazine

PCB-Mar2014

Issue link: https://iconnect007.uberflip.com/i/271756

Contents of this Issue

Navigation

Page 37 of 124

38 The PCB Magazine • March 2014 by Hardeep Heer Firan technology group Behavior of Materials in the Manufacturing Environment Abstract This study was conducted to understand seven materials' reliability, behavior of dielec- tric constant and dissipation factor over me- dium to high frequencies. A modified version of HDPUG design was used for evaluation. This test board contains IST, CAF, thermal cycling and impedance (both microstrip and stripline) coupons. In addition to these we added HATS coupons. Materials were chosen from FR4 family and selection was made based upon our present and future needs. Dielectric constants of these materials ranged from Dk 3.6–Dk 4.2, as published, at 10GHz. This doc - ument shows the effect of Dk and Df values from 10GHz to 20GHz and also shows their performance for lead free assembly process when tested using IST and HATS test methods. In addition, CAF testing was done on five of the seven materials. Introduction As signal speeds are getting higher, a better understanding of material performance is re- quired. Materials which were good at low fre- quencies may not be good for higher frequen- cies. The goal of this study was to: 1. Compare material reliability using HATS and IST test methods. 2. CAF analysis of these materials. 3. Study insertion losses for materials chosen and do a comparison of these materials for frequencies between 1GHz—20GHz. A modified HDPUG design (Figure 2) was adopted as a test vehicle. To keep the testing F e a t u r e

Articles in this issue

Archives of this issue

view archives of PCB007 Magazine - PCB-Mar2014