Issue link: https://iconnect007.uberflip.com/i/1295812
58 DESIGN007 MAGAZINE I OCTOBER 2020 loss, and a higher Dk material will have less radiation loss. However, there are cases where higher radiation loss is desired, and that would be for antenna applications where they have circuit patterns intended to transmit (radiate) energy at a certain frequency. In the case of antenna applications, you will typically find that a lower Dk material is used, but there are exceptions. There is another attribute of Dk that relates to circuit size. In general, circuits using materi- als with a lower Dk value will have a longer wavelength than circuits using material with a higher Dk value. Many RF applications are very sensitive to wavelength, and the designs of the circuit features are very often based on a fraction of wavelength. As an example, a cir- cuit structure intended to resonant will often be designed to have a physical size that relates to half the wavelength for the intended fre- quency of resonance. Expanding on this example, if an RF circuit design is intended to have a resonant peak at 3.6 GHz, it uses 20-mil material; the Dk value of the material is 3.66, so the resonator element should be about 0.97" (24.6mm) in length. However, with that same comparison and the only difference is material with a Dk value of 6.4, the length of the resonator element will reduce to be 0.77" (19.6 mm). That is a size reduction of about 20%, and if a material is used with a Dk value of 11.2, that will give a size reduction of 37%. These different resonator sizes, using materials with different Dk values, will still yield a resonant peak at 3.6 GHz. However, with the decreased resonator size, the other circuit features will also decrease; in some cases, that is not desired. There can be many trade-offs to con- sider when choosing materials with different Dk values. Another thought for Dk differences involves considering coupled features. In RF engineer- ing, there are often circuit features coupled together by their electric fringing fields. These coupled circuit features are used to design and implement many different types of RF filters, directional couplers, and impedance matching networks. The strength of the coupled fields between these circuit features is often critical, and the intensity of the coupled fields will vary with a Dk dependency. A high-frequency circuit using coupled technology and a material with a lower Dk value will have less field intensity than using a circuit material with a higher Dk value. Basically, a circuit material with a higher Dk will cause the fields to concentrate, and they will not spread over a larger area, but they will have higher intensity in a small area. This also goes back to the concept of radiation, where I commented that circuits using mate- rials with high Dk do not radiate as much as circuits using a lower Dk because the fields are more concentrated within the circuit for the high Dk material. This was a quick overview of different things to consider when using high-frequency circuit materials with different Dk values; however, there can be many other issues to consider for different PCB applications. The designer should consult their high-frequency circuit material supplier when dealing with the details of their particular application and understand what the optimum material choice would be for their circuit design. DESIGN007 John Coonrod is technical marketing manager at Rogers Corporation. To read past columns or contact Coonrod, click here. Radiation loss is generally not desired because it is an increase of the signal loss, but there is an additional concern with the radi- ated energy having the potential to corrupt neighboring circuitry.