IPC International Community magazine an association member publication
Issue link: https://iconnect007.uberflip.com/i/1547617
48 I-CONNECT007 MAGAZINE I NOVEMBER 2026 Structural Design and Manufacturing Method Core Structural Design The proposed technology is based on the concept of enabling multiple independent electrical connec- tions within a single plated through-hole. The key structural innovation lies in partitioning the conduc- tive region inside the plated hole by introducing re- cessed isolation rings. Recessed isolation rings are formed at both ends of the interlayer dielectric isolation zone through selective etching of the inner-layer isolation pads. The etching depth is controlled within 0.10–0.25 mm, while the isolation ring height ranges from 5–50 μm with an aspect ratio greater than 5, ensuring reli- able electrical isolation. Within the same plated through-hole, the copper wall between adjacent isolation zones remains elec- trically connected to the corresponding inner-layer circuitry and outer layers. By selectively arranging these isolation structures, electrical interconnec- tion can be established between any desired PCB layers while maintaining complete electrical isola- tion between different signal networks. The structural concept is illustrated in Figure 1, where the recessed isolation rings, plated copper wall, and interlayer dielectric isolation zones together create multiple independent signal trans- mission paths within a single through hole. Manufacturing Process The proposed through-hole any-layer interconnec- tion technology requires only one lamination cycle, one drilling operation, and one electroplating cycle. The manufacturing process consists of the follow- ing key steps. 1. Inner-Layer Fabrication and Lamination After completion of conventional inner-layer fabri- cation and automated optical inspection (AOI), an alkali-soluble ultraviolet (UV)-curable ink is selec- tively deposited onto the pad surfaces of the inner- layer core using inkjet printing technology. Following UV curing, the printed ink forms the isolation pads. Standard inner-layer oxidation treat- ment and multilayer lamination are then carried out according to the PCB stackup design. 2. Drilling and Recessed Isolation Ring Formation Through-holes are mechanically drilled at the des- ignated locations to expose the embedded isola- tion pads. The laminated PCB is subsequently immersed in a 10 wt.% sodium hydroxide (NaOH) solution main- tained at 60°C for 30–120 minutes. During this process, the alkali-soluble isolation material is chemi- cally dissolved, leaving recessed isolation rings with a tapered profile inside the plated through-holes. 3. Electroless Copper Deposition and Electroplating A thin conductive copper layer is first deposited by electroless copper plating, followed by DC flash plating at a current density of 0.8–1.5 ASD for 3–6 minutes to establish an initial copper coating on the hole walls. Reverse pulse electroplating is then employed using the following parameters: • Forward current density: 3 ASD • Forward pulse duration: 10 ms • Reverse current density: 9 ASD • Reverse pulse duration: 10 ms This process selectively removes copper from the isolation regions while maintaining continuous copper deposition in the intended conductive areas, Technical Paper, Part 1 Figure 1: Structure of through-hole any-layer interconnection.

