IPC International Community magazine an association member publication
Issue link: https://iconnect007.uberflip.com/i/1547617
96 I-CONNECT007 MAGAZINE I NOVEMBER 2026 When it was first put to me that I share a "turkey" from my career and show how it ultimately led to a bet- ter understanding of the technology, customer relations, and how to learn from mistakes, I had some reserva- tions. It's not that I haven't made many mistakes. I've always admitted them (most of the time, anyway), but have never had the desire to prolong the experience beyond the initial admis- sion of guilt. They say a smart person learns from their mistakes, and by that standard, I am very well educated indeed. However, it was rightly pointed out that mistakes provide learning experiences, and it is a noble thing to share those learning experiences so that others may benefit. With that in mind, here goes. In the mid-1980s, we had an inquiry from a company that provided brass parts to many manu- facturers. They had been producing their parts by stamping, but they saw their business was changing. Instead of long runs of standardized parts, they were getting orders for short runs of many different parts. Stamping dies was expensive, and they wondered if the parts could be etched. We told them, of course, they could and offered to demonstrate, since this was new technology for them. They visited with some of their parts, which we duly etched for them. They were delighted, and I was asked to calculate how many etch chambers would be needed to handle their business volume. Well, this was an easy assignment since we had just etched the parts and knew exactly what the etch rates were. It was a quick calculation. I reported that they needed three etch chambers. The quotes were prepared and accepted, and the equipment was purchased, built, delivered, and installed. Things went well for the first several weeks. Then the customer asked why the etch rate was starting to fall off. We went through the regular trouble- shooting steps (plugged nozzles, low free acid, etc.), but nothing helped. While we were trying to figure out what was wrong, the etch rate stabilized but was 30% slower than the new cupric etch bath they had started with, and they were no longer able to keep up with their production. A Career 'Turkey' Story for November T H E C H E M I CA L C O N N ECT I O N BY D O N BA L L , C H E M C U T

