I-Connect007 Magazine

I007-Nov2026

IPC International Community magazine an association member publication

Issue link: https://iconnect007.uberflip.com/i/1547617

Contents of this Issue

Navigation

Page 116 of 129

NOVEMBER 2026 I I-CONNECT007 MAGAZINE 117 H A P PY'S T EC H TA L K # 51 Principle of Operation The simplest method of analysis is shown in Figure 3a. An LED is used to emit a specific wavelength of light, which passes through a glass cuvette containing a solution, where the light is absorbed by the liquid and detected by a photoreceptor. Figure 3b shows these three elements. 2 Sensor Design A tungsten light is typically used as the Vis-IR light source, and a deuterium-tungsten lamp is used for UV-Vis. The wavelength separation is performed by a ruled grating or monochromator, using a photodetector, photoresistor, or cadmium sulfide sensor. The old Spectronic 20 used a photomultiplier tube, but current instruments use various solid-state detectors and sensors, such as the DAS. Three of these components are illustrated in Figures 4b and c. Figure 3: a) Simple schematic of a colorimeter: batteries (A), control resistor (B), LED light source (C), sample cuvette (D), photo sensor (E), sample cap (F), display device (G); b) The three principal elements. Figure 4: a) The various wavelengths of LEDs available today: UV and infrared LEDs, from 200 to 940 nm; b) LEGO® blocks are constructed for the case and housings; c) An old camera phone can be used as a sensor, and a monochromator slide can filter white light. Pieces of old CD can be used as gratings as well because of the density of pits in the polycarbonate plastic; d) The LED source and the LED photodetector are mounted in LEGO single brick pieces.

Articles in this issue

view archives of I-Connect007 Magazine - I007-Nov2026