I-Connect007 Magazine

I007-Nov2026

IPC International Community magazine an association member publication

Issue link: https://iconnect007.uberflip.com/i/1547617

Contents of this Issue

Navigation

Page 26 of 129

NOVEMBER 2026 I I-CONNECT007 MAGAZINE 27 Start the Layout Once you have these items defined, you are ready to start laying out the actual circuitry. This can be done most effectively with layout software, but it can also be done manually using various types of CAD software. If you are not comfortable with this step, most suppliers can offer this internally or through a third party. Define the Stackup Dynamic applications should be as thin as possible and utilize RA copper, but within reason. Some of the very thin polyimides (12-micron or thinner), copper below half an ounce, and adhesives under 25 microns do not lend themselves well to dynamic applications. A good starting point is one half-ounce copper, 1-mil polyimide dielectrics, and 1-mil adhe- sives. Avoid flexible solder masks in bend areas. You will need to consider any electrical require- ments, including how much current you need to carry on certain traces. This will determine the cross-sectional area of the conductors required to carry your current without overheating the trace. Impedance requirements usually come with a need for greater dielectric separation between signal and reference planes. Often, your electrical requirements will push you in the opposite direction from where you would like to be to meet your mechanical needs (bend require- ments). This is often a reiterative process to arrive at a finished design. At times, you will need to go back a step or two as you uncover issues. Create Your Complete Procurement Package • Use Gerber data. • Prints including both assembly and the bare circuit level, as well as those required for custom components, should be generic where possible and detailed where needed. • Do not over-dimension and apply overly critical tolerances. All too often customers apply tolerances similar to those found on a machined part. This is not realistic. • Include a bill of materials. The final step is to request a quote for your project. Obviously, there is more to each of these steps, but the important thing is to work with your supplier as much as possible along the way. Good suppliers should be more than willing to work with you on your designs. Everyone wins if the end product is as simple and producible as possible. I-CONNECT007 Chris Clark is a senior principal applications engineer at Flexible Circuit Technologies. To read past columns from Flexible Circuit Technologies, click here. Figure 2: a) Stiffened flex b) Rigid-flex. FLEX007 | F L E X C O N N ECT I O N S

Articles in this issue

Links on this page

view archives of I-Connect007 Magazine - I007-Nov2026