I-Connect007 Magazine

I007-Nov2026

IPC International Community magazine an association member publication

Issue link: https://iconnect007.uberflip.com/i/1547617

Contents of this Issue

Navigation

Page 49 of 129

50 I-CONNECT007 MAGAZINE I NOVEMBER 2026 thereby producing precisely partitioned conductive paths within a single through-hole. Finally, conventional DC electroplating or a seconwdary pulse-plating process is performed to increase the final copper thickness, ensuring both electrical conductivity and long-term structural reliability. Process Development and Optimization The manufacturing process was optimized through several rounds of experimental validation. During the initial trial, the isolation zones partially overlapped with the inner-layer pads, resulting in incomplete electrical partitioning and preventing independent signal transmission. The second trial successfully achieved electrical partitioning; however, excessive copper extension occurred around the recessed isolation regions, leading to localized plating defects. By optimizing both the dimensions of the isola- tion pads and the electroplating parameters during the third development cycle, stable transmission of multiple independent signal networks through a single plated through-hole was achieved, thereby realizing the intended through-hole any-layer inter- connection concept. Representative cross-sectional micrographs of the optimized structure are shown in Figure 2. Core Application Solutions Based on Through-hole Any-layer Interconnection Building upon the through-hole any-layer inter- connection technology described above, several application-specific solutions have been developed to address three major challenges in modern PCB manufacturing: thick-copper adaptation, high den- sity BGA fan-out optimization, and efficient utiliza- tion of outer-layer routing space. Together, these solutions establish a comprehensive technology platform that combines a fundamental interconnec- tion process with application-oriented optimization. Thick-copper PCB Solution Thick-copper PCBs are widely used in high-current applications such as automotive power electronics, industrial control systems, and power conversion equipment. However, conventional manufacturing processes often suffer from poor etching accuracy, excessive undercut, and lamination voids when copper thickness reaches 4 ounces or greater. The proposed through-hole any-layer inter- connection technology addresses these issues through an innovative "copper layer segmentation + through-hole interconnection" architecture. 1. Structural Design Instead of employing a single ultra-thick copper layer, the proposed design divides a copper layer of 4 ounces or more into two overlapping copper layers of 2 ounces or greater, which are electrically connected through plated through-holes. From an electrical perspective, the current path is equivalent to two conductors connected in parallel, Figure 2: Cross-section of through-hole any-layer interconnection. Figure 3: Thick-copper PCB structure. Technical Paper, Part 1

Articles in this issue

view archives of I-Connect007 Magazine - I007-Nov2026