I-Connect007 Magazine

I007-Nov2026

IPC International Community magazine an association member publication

Issue link: https://iconnect007.uberflip.com/i/1547617

Contents of this Issue

Navigation

Page 51 of 129

52 I-CONNECT007 MAGAZINE I NOVEMBER 2026 1. Top-layer Pad Design The top-layer BGA pads are designed with a diameter of 0.25 mm, while pad spacing is reduced to 50 μm. No fan-out traces are routed on the top layer. Instead, signals are transferred directly into the designated inner routing layer through plated through-holes. 2. Inner-layer Fan-Out Design The inner-layer fan-out uses 150 μm-diameter vias while maintaining a minimum copper-to-copper spacing of 150 μm. This configuration provides suffi- cient routing space for 50 μm trace widths between adjacent vias. The principal design parameters are summarized as follows: • Via pitch: 300 μm • Trace-to-via clearance: 50 μm • Pad-to-pad spacing: 50 μm Capture pads are provided only on the top layer and the designated fan-out layer. Additional vias are progressively fanned outward, reserving routing channels for signals originating from the inner rows of the BGA package. Compared with conventional HDI structures, this design provides shorter signal paths, improved routing efficiency, and enhanced signal integrity. Outer-layer Partitioning and Routing Space Optimization Based on the through-hole any-layer interconnec- tion process, two outer-layer partitioning tech- niques have been developed to eliminate unneces- sary through-hole occupation on the PCB surface and recover valuable routing area. 1. Solder Mask Filling Method After completion of through-hole electroplating, the vias are vacuum-filled with resin and planarized. During subsequent outer-layer circuit fabrication and solder mask processing, the exposed copper around the partitioned via is naturally removed through the normal etching process and replaced with solder mask material. As a result, the outer-layer portion of the via becomes electrically isolated while routing traces can be placed adjacent to the partitioned region. 2. Plated-Over-Filled-Via (POFV) Method Following resin filling and planarization, windows are selectively opened in the outer copper layer above the partitioned vias to interrupt the electrical connection between the outer layer and the inter- nal conductive structure. The vias are subsequent- ly filled again, planarized, and processed through Figure 7: Cross-section of BGA fan-out routing. Figure 6: Top-layer BGA pad design. Technical Paper, Part 1

Articles in this issue

view archives of I-Connect007 Magazine - I007-Nov2026