IPC International Community magazine an association member publication
Issue link: https://iconnect007.uberflip.com/i/1547617
58 I-CONNECT007 MAGAZINE I NOVEMBER 2026 The book will also cover why transmission lines are needed in PCBs at high speeds and where you are likely to encounter them, as well as some of the con- sequences of omitting to consider interconnects as transmission lines. Then we discuss how fabricators control the char- acteristic impedance of on-board transmission lines through careful material selection and control of line widths and trace separation. For higher speed designs, we introduce the concept of insertion loss and explain its interplay with characteristic imped- ance. More importantly, we list the physical drivers that control insertion loss and contrast them with those that govern characteristic impedance. I find it fascinating that in the early days of high-speed electronics, coaxial cables were used to route the high- speed signals point-to-point on a PCB. The cost and scale reduction by using transmission lines built into the structure of the PCB itself has been one of many key factors in the advancement of PCB capability over the half-century that Polar has been part of in the industry. The Introduction of UHDI We published our first introduction to controlled im- pedance when 10- or 15-mil traces were commonplace. The 10- to 25-micron traces of UHDI were unheard of, but they are with us now, and Chapter 14 explains what to expect when measuring and modelling at these line dimensions. At the time, those line widths would have been in silicon, not the PCB fabrication arena. People who are new to the industry are faced with an enormous variety, from simple single- and double-sided PCBs, which are still workhorses in many designs, through to the most complex and demanding high layer count rigid and flex-rigid PCBs. I trust this new introduction sheds some light on one of the many specialist areas that are required for PCB production. It has been interesting and refreshing to update introductory information for a new generation of PCB enthusiasts. I hope it encourages deeper learning and a hunger to empathise with all the technology specialists who are called on to mix disciplines and produce modern high layer count high-speed printed circuits. Please keep an eye out for publication dates. Click here to get on an early waiting list. I-CONNECT007 Martyn Gaudion is managing di- rector of Polar Instruments Ltd. To read past columns, click here. Martyn is the author of The Print- ed Circuit Designer's Guide to… Secrets of High-Speed PCBs, Part 1 and Part 2, and The Print- ed Circuit Designer's Guide to… More Secrets of High-speed PCBs. Figure 2: UHDI transmission lines take high speed into new dimensions. T H E P U LS E

