SMT007 Magazine

SMT007-Jan2024

Issue link: https://iconnect007.uberflip.com/i/1513827

Contents of this Issue

Navigation

Page 41 of 85

42 SMT007 MAGAZINE I JANUARY 2024 Challenges with rework of underfilled com- ponents include but are not limited to the fol- lowing: 1. Solder displacement: Soened underfill can displace solder at elevated temperatures which can result in defects. 2. Can be expensive: Low yields and prohib- itive cost of long processing times for experi- enced "high touch" rework are typical. 3. PCB damage: e underfilled rework process may cause laminate damage, mask destruction, and lied pads, impacting reli- ability, and resulting in additional repairs. 4. Difficult rework: Due to the inherent instability of underfilled components, tradi- tional rework methods using thermal or ther- mal/mechanical options become less feasible. e process begins with thoroughly examin- ing the board to identify any components that might interfere with milling. Using a univer- sal fixture which accommodates most PCBs, we mount the board onto the mill platform. Subsequently, the mill is programmed to pre- cisely locate the component, measure board coplanarity, and determine its depth relative to the board. Shaving off layers as thin as a few microns per pass, the mill continually assesses coplanarity and depth while grad- ually approaching an appropriate depth above the pads. e remnant solder becomes the pre-tinned pad for the replacement component. Cold milling becomes a viable alter- native for component removal under specific conditions: • High risk of heat damage to the PCB or rework location • Components can be sacrificed during the removal process • Previous issues arising from traditional heat-based removal methods • Underfilled components requiring rework Benefits of cold milling: • No additional thermal stress and associated risks • e mill contains an integrated active ionizing source reducing the risk of ESD-related issues • A vacuum chuck surrounding the bit which removes debris as material is milled • Laser-based measurement system for precision cuts within 0.001" from the board surface • Cost-effective • Expedited lead-times (depending on quantity) Risks with cold milling: • Pad damage especially when no underfill is present • Milling too deep exposing the copper layer • Physical damage to adjacent components if not removed prior to milling SMT007 Bob Wettermann is the former president of BEST, Inc.

Articles in this issue

Archives of this issue

view archives of SMT007 Magazine - SMT007-Jan2024