Issue link: https://iconnect007.uberflip.com/i/652863
42 The PCB Design Magazine • March 2016 Sounds like the opening words of a bad joke [1] . Well, here's the answer, and it's no joke: One! That's right. No matter how much current you are putting down the trace, all you need is a single via. And a small one, at that. OK, that last statement might not be true in EVERY single case. But it is true in a LOT more cases than you think. I will explain why in this column. During 2015, I enjoyed a very productive collaboration with Dr. Johannes Adam, from Leimen, Germany. That collaboration resulted in several papers, but one in particular is rel- evant for this column, "Via Currents and Tem- peratures" [2] . In that paper, we used a simula- tion tool, thermal risk management (TRM), developed by Dr. Adam [3] , to simulate current flowing through a via and then determine the temperature of the via. The conventional wis- dom is that the conducting cross-sectional area of the via should be the same as (or greater than) the cross-sectional area of the trace (conductor.) IPC 2152 explicitly endorses this [4] : The cross-sectional area of a via should have at least the same cross-sectional area as the con- ductor or be larger than the conductor coming into it. If the via has less cross-sectional area than the conductor, then multiple vias can be used to maintain the same cross-sectional area as the conductor. But our results contradicted this; they sug- gested that the temperature of the via was con- trolled by the trace, and as long as the trace was sized correctly, any old (single) via was good enough. If there was ever a result that cried out "show me," this was it. So I set out on a path to build a test board, test it, and verify the simulation results. This type of study would not have been possible without the cooperation of several people and organizations. In particular, I want to thank my longtime partner Dave Graves (now with Monsoon Solutions in Bellevue, Washington) for helping prepare the final artwork for the test by Douglas G. Brooks ultracad How Many Vias Does It Take To…? Brooks' Bits